No Installation Required, Instantly Prepare for the 2V0-41.23 exam and please click the below link to start the 2V0-41.23 Exam Simulator with a real 2V0-41.23 practice exam questions.
Use directly our on-line 2V0-41.23 exam dumps materials and try our Testing Engine to pass the 2V0-41.23 which is always updated.
Where does an administrator configure the VLANs used In VRF Lite? (Choose two.)
Correct Answer:BD
According to the VMware NSX Documentation, these are the two places where you need to configure the VLANs used in VRF Lite:
Uplink trunk segment: This is a segment that connects a tier-0 gateway to a physical network using multiple VLAN tags. You need to configure the VLAN IDs for each VRF on this segment.
Uplink interface of the VRF gateway: This is an interface that connects a VRF gateway to an uplink trunk segment using a specific VLAN tag. You need to configure the VLAN ID for each VRF on this interface.
When collecting support bundles through NSX Manager, which files should be excluded for potentially containing sensitive information?
Correct Answer:C
According to the VMware NSX Documentation1, core files and audit logs can contain sensitive information and should be excluded from the support bundle unless requested by VMware technical support. Controller files and management files are not mentioned as containing sensitive information.
Which two of the following will be used for Ingress traffic on the Edge node supporting a Single Tier topology? (Choose two.)
Correct Answer:BC
The two interfaces that will be used for ingress traffic on the Edge node supporting a Single Tier topology are:
B. Tier-0 Uplink interface C. Downlink Interface for the Tier-0 DR
The Tier-0 Uplink interface is the interface that connects the Tier-0 gateway to the external network. It is used to receive traffic from the physical router or switch that is the next hop for the Tier-0 gateway. The Tier-0 Uplink interface can be configured with a static IP address or use BGP to exchange routes with the external network.
The Downlink Interface for the Tier-0 DR is the interface that connects the Tier-0 gateway to the workload segments. It is used to receive traffic from the VMs or containers that are attached to the segments. The Downlink Interface for the Tier-0 DR is a logical interface (LIF) that is distributed across all transport nodes that host the segments. The Downlink Interface for the Tier-0 DR has an IP address that acts as the default gateway for the VMs or containers on the segments.
An NSX administrator would like to create an L2 segment with the following requirements:
• L2 domain should not exist on the physical switches.
• East/West communication must be maximized as much as possible.
Which type of segment must the administrator choose?
Correct Answer:B
An overlay segment is a layer 2 broadcast domain that is implemented as a logical construct in the NSX-T Data Center software. Overlay segments do not require any configuration on the physical switches, and they allow for optimal east/west communication between workloads on different ESXi hosts. Overlay segments use the Geneve protocol to encapsulate and decapsulate traffic between the hosts. Overlay segments are created and managed by the NSX Manager.
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.2/administration/GUID-316E5027-E588-455C-88
An NSX administrator has deployed a single NSX Manager node and will be adding two additional nodes to form a 3-node NSX Management Cluster for a production environment. The administrator will deploy these two additional nodes and Cluster VIP using the NSX UI.
What two are the prerequisites for this configuration? (Choose two.)
Correct Answer:DE
According to the VMware NSX Documentation, these are the prerequisites for adding nodes to an NSX Management Cluster using the NSX UI:
All nodes must be in the same subnet and have IP connectivity with each other. A compute manager must be configured and associated with the NSX Manager node. 
The NSX Manager node must have a valid license. The NSX Manager node must have a valid certificate.