Free 300-410 Exam Dumps

No Installation Required, Instantly Prepare for the 300-410 exam and please click the below link to start the 300-410 Exam Simulator with a real 300-410 practice exam questions.
Use directly our on-line 300-410 exam dumps materials and try our Testing Engine to pass the 300-410 which is always updated.

Exam Code: 300-410
Exam Title: Implementing Cisco Enterprise Advanced Routing and Services (ENARSI)
Vendor: Cisco
Exam Questions: 214
Last Updated: December 18th,2024

Question 1

Which command allows traffic to load-balance in an MPLS Layer 3 VPN configuration?

A. multi-paths eibgp 2
B. maximum-paths 2
C. maximum-paths ibgp 2
D. multi-paths 2

Correct Answer:B

Question 2

Which statement about IPv6 ND inspection is true?

A. It learns and secures bindings for stateless autoconfiguration addresses in Layer 3 neighbor tables.
B. It learns and secures bindings for stateless autoconfiguration addresses in Layer 2 neighbor tables.
C. It learns and secures bindings for stateful autoconfiguration addresses in Layer 3 neighbor tables.
D. It learns and secures bindings for stateful autoconfiguration addresses in Layer 2 neighbor tables.

Correct Answer:B

Question 3

Refer to the exhibit.
300-410 dumps exhibit
An engineer is troubleshooting BGP on a device but discovers that the clock on the device
does not correspond to the time stamp of the log entries. Which action ensures consistency between the two times?

A. Configure the service timestamps log uptime command in global configuration mode.
B. Configure the logging clock synchronize command in global configuration mode.
C. Configure the service timestamps log datetime localtime command in global configuration mode.
D. Make sure that the clock on the device is synchronized with an NTP server.

Correct Answer:D

Question 4

Drag and drop the OSPF adjacency states from the left onto the correct descriptions on the right.
300-410 dumps exhibit
Solution:

Does this meet the goal?

A. Yes
B. No

Correct Answer:A

Question 5

Which statement about IPv6 RA Guard is true?

A. It does not offer protection in environments where IPv6 traffic is tunneled.
B. It cannot be configured on a switch port interface in the ingress direction.
C. Packets that are dropped by IPv6 RA Guard cannot be spanned.
D. It is not supported in hardware when TCAM is programmed.

Correct Answer:A