Free 300-410 Exam Dumps

Question 11

Which configuration enabled the VRF that is labeled “Inet” on FastEthernet0/0?

A. R1(config)# ip vrf InetR1(config-vrf)#ip vrf FastEthernet0/0
B. R1(config)#ip vrf Inet FastEthernet0/0
C. R1(config)# ip vrf InetR1(config-vrf)#interface FastEthernet0/0 R1(config-if)#ip vrf forwarding Inet
D. R1(config)#router ospf 1 vrf InetR1(config-router)#ip vrf forwarding FastEthernet0/0

Correct Answer:C

Question 12

Refer to the exhibit.
300-410 dumps exhibit
What is the result of applying this configuration?

A. The router can form BGP neighborships with any other device.
B. The router cannot form BGP neighborships with any other device.
C. The router cannot form BGP neighborships with any device that is matched by the access list named “BGP”.
D. The router can form BGP neighborships with any device that is matched by the access list named “BGP”.

Correct Answer:D

Question 13

Drag and drop the SNMP attributes in Cisco IOS devices from the left onto the correct SNMPv2c or SNMPV3 categories on the right.
300-410 dumps exhibit
Solution:

Does this meet the goal?

A. Yes
B. No

Correct Answer:A

Question 14

Which statement about MPLS LDP router ID is true?

A. If not configured, the operational physical interface is chosen as the router ID even if a loopback is configured.
B. The loopback with the highest IP address is selected as the router ID.
C. The MPLS LDP router ID must match the IGP router ID.
D. The force keyword changes the router ID to the specified address without causing any impact.

Correct Answer:B

Question 15

Refer to the exhibit.
300-410 dumps exhibit
R2 is a route reflector, and R1 and R3 are route reflector clients. The route reflector learns
the route to 172.16.25.0/24 from R1, but it does not advertise to R3. What is the reason the route is not advertised?

A. R2 does not have a route to the next hop, so R2 does not advertise the prefix to other clients.
B. Route reflector setup requires full IBGP mesh between the routers.
C. In route reflector setup, only classful prefixes are advertised to other clients.
D. In route reflector setups, prefixes are not advertised from one client to another.

Correct Answer:A