Free 300-510 Exam Dumps

Question 11

Which task is performed when troubleshooting LDP?

A. Execute the ping utility to generate information about the MAC addresses used along the path
B. Verify that MPLS is disabled globally and enabled on the necessary interfaces in a per-interface basis
C. Execute the traceroute utility to generate information about the labels used along the path
D. Verify that Cisco Express Forwarding has been disabled on the network

Correct Answer:C

Question 12

For which reason can two BGP peers fail to establish a neighbor relationship?

A. Their BGP send-community strings are misconfigured
B. Their BGP timers are mismatched
C. Their remote-as numbers are misconfigured
D. They are both activated under an IPv4 address family

Correct Answer:C

Question 13

300-510 dumps exhibit
Refer to the exhibit. P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which action fixes the issue?

A. Change HMAC-MD5 to HMAC-SHA1-20
B. Configure the send and accept lifetime under key 1
C. Change HMAC-MD5 to MD5
D. Change HMAC-MD5 to HMAC-SHA1-12

Correct Answer:B

Question 14

300-510 dumps exhibit
Refer to the exhibit. An engineer is addressing an IS-IS design issue which is running within the topology. All links are running on FastEthernet, except the link between R5 and R4, which is Gigabit Ethernet. Which statement about the design is true?

A. R4 prefer to reach R5 using R1 as the next hop
B. All links have equal cost if the default metric is used
C. R5 prefers to use R4 as the next hop for all routes
D. R1 prefer to use R5 as the next hop to reach R4

Correct Answer:B

Question 15

300-510 dumps exhibit
Refer to the exhibit. A network operator must stop 10.33.33.33/32 from being redistributed into Level 1 router XR1. Which configuration meets this need?

Correct Answer:C