Free 300-515 Exam Dumps

No Installation Required, Instantly Prepare for the 300-515 exam and please click the below link to start the 300-515 Exam Simulator with a real 300-515 practice exam questions.
Use directly our on-line 300-515 exam dumps materials and try our Testing Engine to pass the 300-515 which is always updated.

Exam Code: 300-515
Exam Title: Implementing Cisco Service Provider VPN Services (SVPI)
Vendor: Cisco
Exam Questions: 71
Last Updated: December 18th,2024

Question 1

- (Exam Topic 1)
The CTO of a company requires the support of a network consultant to deliver an MPLS solution without resigning to a certain degree of redundancy and scalability. Which solution effectively scales to hundreds or thousands of sites?

A. L2VPN with the broadcast traffic processed at the ingress PE.
B. L3VPN with direct LSP connectivity between all PEs.
C. L2VPN by encapsulating multiple frame formats with interworking.
D. L3VPN using a hierarchical topology of N-PEs and U-PEs.

Correct Answer:D

Question 2

- (Exam Topic 1)
While configuring the VRF Selection feature, you get an error message after typing the below statement: Router(config)#no vrf selection source 172.16.0.0 255.255.0.0 vrf VRF1
Which action caused this message?

A. the entry of an inconsistent IP address and mask for VRF Selection
B. an attempt to configure a VRF instance on an interface that already has VRF Selection configured
C. an attempt to remove a VRF Selection entry that does not exist
D. an attempt to configure a VRF Selection table that does not exist

Correct Answer:C
Reference: https://www.cisco.com/c/en/us/td/docs/ios/12_2/12_2sz/feature/guide/122szvrf.html

Question 3

- (Exam Topic 3)
You are writing the requirements for an MPLS L3VPN environment that uses MP-BGP between PE routers. In this environment, route targets and route distinguishers need to be advertised between the PE routers.
Which three operations meet these requirements? (Choose three.)

A. mandatory creation of PE-to-PE BGP sessions between the outgoing interface IP addresses
B. advertisement of standard communities, enabled on the PE-to-PE BGP neighbors
C. creation of PE-to-PE BGP sessions between loopback IP addresses
D. full mesh of IBGP sessions
E. full mesh of EBGP sessions and partial mesh of IBGP sessions
F. advertisement of extended communities, enabled on the PE-to-PE BGP neighbors

Correct Answer:CDF

Question 4

- (Exam Topic 4)
Refer to the exhibit.
300-515 dumps exhibit
An organization is running H-VPLS on a network comprising four routers in a hub-and-spoke topology with R1 as the hub An engineer added a new spoke with multiple VCs to the network, and now traffic cannot flow properly How should the engineer update the configuration on R1 to correct the problem?

A. Disable spanning tree to allow loops to occur within the hub-and-spoke topology.
B. Disable split horizon to allow multiple VCs per spoke
C. Disable Cisco Discovery Protocol to allow MPLS to share labels between the designated spokes
D. Disable Cisco Discovery Protocol to allow for neighbor discovery

Correct Answer:B

Question 5

- (Exam Topic 1)
In a typical service provider environment, which two tools are used to help scale PE router connectivity requirements? (Choose two.)

A. route reflectors
B. VPNv4 address family
C. originator ID
D. cluster ID
E. confederations

Correct Answer:AE