Free 300-815 Exam Dumps

No Installation Required, Instantly Prepare for the 300-815 exam and please click the below link to start the 300-815 Exam Simulator with a real 300-815 practice exam questions.
Use directly our on-line 300-815 exam dumps materials and try our Testing Engine to pass the 300-815 which is always updated.

Exam Code: 300-815
Exam Title: Implementing Cisco Advanced Call Control and Mobility Services (CLACCM)
Vendor: Cisco
Exam Questions: 118
Last Updated: December 18th,2024

Question 1

300-815 dumps exhibit
Refer to the exhibit. Users report that outbound PSTN calls from phones registered to Cisco Unified Communications Manager are not completing. The local service provider in North America has a requirement to receive calls in 10-digit format. The Cisco Unified CM sends the calls to the Cisco Unified Border Element router in a globalized E.164 format. There is an outbound dial peer on Cisco Unified Border Element configured to send the calls to the provider. The dial peer has a voice translation profile applied in the correct direction but an incorrect voice translation rule applied, which is shown in the exhibit. Which rule modified DNIS in the format that the provider is expecting?

A. rule 1 /^/+$[^1].*$/ /011\1/
B. rule 1/^\+1$[2-9]..[2-9]……$$/ /\1/
C. rule 1 /^$[2-9]..[2-9]……$$/ /\1/
D. rule 1 /^\+1$[2-9]..[2-9]……$$/ /\0/

Correct Answer:B

Question 2

An administrator is troubleshooting call failures on an H.323 gateway via the CLI. To see signaling for media and call setup, which debug must the Administrator turn on?

A. debug H.323 messages
B. debug H.225 asn1
C. debug H.246 asn 1
D. debug H.225 media
E. debug H.323 asn 1

Correct Answer:B

Question 3

Which description of RTP timestamps or sequence numbers is true?

A. The sequence number is used to detect losses.
B. Timestamps increase by the time “carrying” by a packet.
C. Sequence numbers increase by four for each RTP packet transmitted.
D. The timestamp is used to place the incoming audio and video packets in the correct timing order (playout delay compensation).

Correct Answer:D

Question 4

Cisco SIP IP telephony is implemented on two floors of your company. Afterward, users report intermittent voice issues in calls established between floors. All calls are established, and sometimes they work well, but sometimes there is oneway audio or no audio. You determine that there is a firewall between the floors, and the administrator reports that it is allowing SIP signaling and UDP ports from 20000 to 22000 bidirectionally. What are two possible solutions? (Choose two.)

A. Go to the SIP profile assigned to these IP phones in Cisco Unified CM and change the range of media ports to 16384-32767
B. Ask the firewall administrator to change the ports to TCP.
C. Ask the firewall administrator to change the range of UDP ports to 16384-32767.
D. Go to the SIP profile assigned to these IP phones in Cisco Unified CM and change the range of media ports to 20000-22000.
E. Go to System Parameters in Cisco Unified Communications Manager and change the range of media ports to 20000-22000.

Correct Answer:AC

Question 5

A company has an SRST gateway running an IOS XE image. The company plans to enable the IPv6 addressing companywide. To enable the IPv6 in a unified SRST gateway to support SIP phones, what are two supported supplementary features for an IPv6 fallback scenario? (Choose two.)

A. three-way conference
B. secure SIP lines
C. T.38 fax relay
D. transcoding
E. SIP trunk

Correct Answer:AC