Free 350-401 Exam Dumps

Question 81

- (Exam Topic 1)
Refer to the exhibit.
350-401 dumps exhibit
An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?

A. SPAN session 1 monitors activity on VLAN 50 of a remote switch
B. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.
C. SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15.
D. RSPAN session 1 is incompletely configured for monitoring

Correct Answer:D
SW1 has been configured with the following commands:
SW1(config)#monitor session 1 source remote vlan 50 SW1(config)#monitor session 2 source interface fa0/14 SW1(config)#monitor session 2 destination interface fa0/15
The session 1 on SW1 was configured for Remote SPAN (RSPAN) while session 2 was configured for local SPAN. For RSPAN we need to configure the destination port to complete the configuration.
Note: In fact we cannot create such a session like session 1 because if we only configure Source RSPAN VLAN 50 (with the command monitor session 1 source remote vlan 50) then we will receive a Type: Remote Source Session (not Remote Destination Session).

Question 82

- (Exam Topic 4)
Refer to the exhibit.
350-401 dumps exhibit
An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEtherenet1 interface. Which two commands must be added to the existing configuration to accomplish this task? (Choose two.)

A. Router(config-vrf)#ip address 192.168.1.1 255.255.255.0
B. Router(config-vrf)#address-family ipv4
C. Router(config-if)#address-family ipv4
D. Router(config-vrf)#address-family ipv6
E. Router(config-if)#ip address 192.168.1.1 255.255.255.0

Correct Answer:BE

Question 83

- (Exam Topic 3)
Which benefit is realized by implementing SSO?

A. IP first-hop redundancy
B. communication between different nodes for cluster setup
C. physical link redundancy
D. minimal network downtime following an RP switchover

Correct Answer:D

Question 84

- (Exam Topic 3)
Which option works with a DHCP server to return at least one WLAN management interface IP address during the discovery phase and is dependent upon the VCI of the AP?

A. Option 42
B. Option 15
C. Option 125
D. Option 43

Correct Answer:D

Question 85

- (Exam Topic 2)
Refer to the exhibit.
350-401 dumps exhibit
A network architect has partially configured static NAT. which commands should be asked to complete the configuration?

A. R1(config)#interface GigabitEthernet0/0 R1(config)#ip pat outside R1(config)#interface GigabitEthernet0/1 R1(config)#ip pat inside
B. R1(config)#interface GigabitEthernet0/0 R1(config)#ip nat outside R1(config)#interface GigabitEthernet0/1 R1(config)#ip nat inside
C. R1(config)#interface GigabitEthernet0/0 R1(config)#ip nat inside R1(config)#interface GigabitEthernet0/1 R1(config)#ip nat outside
D. R1(config)#interface GigabitEthernet0/0 R1(config)#ip pat inside R1(config)#interface GigabitEthernet0/1 R1(config)#ip pat outside

Correct Answer:B