Free 352-001 Exam Dumps

Question 31

Which IEEE standard is commonly used at the data link layer for an access network, in an IoT environment?

A. Wireless Regional Area Network
B. Low-Rate Wireless Network
C. Wireless Local Area Network
D. Broadband wireless metropolitan Network

Correct Answer:B

Question 32

VPLS is implemented in a Layer 2 network with 2000 VLANs. Which must be the primary concern to
ensure successful deployment of VPLS?

A. The underlying transport mechanism
B. PE scalability
C. Flooding is necessary to propagate MAC address reachability information
D. VLAN scalability

Correct Answer:C
[ I think B not 100% sure]

Question 33

Refer to the exhibit.
352-001 dumps exhibit
Transit traffic in this large enterprise campus network passes the eBGP core. Per security policy, traffic coming from AS 65444 destined for AS 65466 and vice-versa must pass through AS 65400. An audit discovers that traffic between 65444 and 65466 did not pass through 65400, instead it is communicating directly. How must you design BGP to ensure that the traffic from AS 65444 destined for AS 65466 passes through AS65400 on this broadcast network?

A. Apply an ACL on AS 65466 to drop the direct traffic between AS 65444 and AS 65466
B. Apply AS-path prepending on AS 65466 and AS 65444
C. Apply next-hop self on both BGP neighbors on AS 65400
D. Apply the MED attribute on the BGP session for AS 65444

Correct Answer:C

Question 34

Which two statements about VXLAN are true? (Choose two)

A. VXLAN is a Cisco proprietary solution
B. VXLAN is an encapsulation method used to create a Layer 3 overlay network
C. VXLAN can be used to enforce Layer 2 isolation in a multitenant infrastructure
D. VXLAN uses the Spanning Tree protocol for loop prevention
E. VXLAN overcomes the 802.1Q virtual LAN address space limitation

Correct Answer:BE

Question 35

A network has several routers running IS-IS L1L2 mode on the same Ethernet segment. Which action
reduces to a minimum the number of IS-IS adjacencies in this segment?

A. Define only the router on the segment to be DIS
B. Change all routers connected to this segment to a single-level area
C. Make the interface priority on the backup DIS lower than the primary DIS
D. Change half the routers to be L1-only and other half to be L2-only on this segment

Correct Answer:B