Fortinet FCSS_NST_SE-7.4 Dumps (FCSS_NST_SE-7.4 exam questions Free)

Question 11

Exhibit.
FCSS_NST_SE-7.4 dumps exhibit
Refer to the exhibit, which contains a screenshot of some phase 1 settings.
The VPN is not up. To diagnose the issue, the administrator enters the following CLI commands on an SSH session on FortiGate:

However, the IKE real-time debug does not show any output. Why?

A. The administrator must also run the command diagnose debug enable.
B. The debug shows only error message
C. If there is no output, then the phase 1 and phase 2 configurations match.
D. The log-filter setting is incorrec
E. The VPN traffic does not match this filter.
F. Replace diagnose debug application ike -1 with diagnose debug application ipsec -1.

Correct Answer:A

Question 12

Refer to the exhibit, which shows the output of a BGP debug command.
FCSS_NST_SE-7.4 dumps exhibit
Whatcan you conclude about the router in this scenario?

A. The router 100.64.3.1 needs to update the local AS number in its BGP configuration in order to bring up the 8GP session with the local router.
B. An inbound route-map on local router is blocking the prefixes from neighbor 100.64.3.1.
C. All of the neighbors displayed are part of a single BGP configuration on the local router with the neighbor-range set to a value of 4.
D. The BGP session with peer 10.127.0.75 is up.

Correct Answer:D

Free FCSS_NST_SE-7.4 Exam Dumps

Question 11

Question 12