Free H12-811_V1.0 Exam Dumps

Question 111

- (Exam Topic 3)
For the description of the PPP link establishment process, the following statement is wrong ()

A. In the Establish phase, the PPP link performs LCP parameter negotiatio
B. The negotiation content includes the maximum receiving unit MRU, authentication method magic word and other options
C. After the NCP negotiation is successful, the PPP link will maintain the communication state and enter the Terminate phase
D. The Dead phase is also called the physical layer unavailable phas
E. When both ends of the communication parties detect that the physical circuit is activated, they will migrate from the Dead phase to the Establish phase, which is the link establishment phase.
F. In the Network phase, the PPP link performs NCP negotiatio
G. Select and configure a network layer protocol through NCP negotiation, E.PPP link supports half-duplex and full-duplex modes

Correct Answer:B

Question 112

- (Exam Topic 2)
What elements can NAPT transform? ()

A. Only IP address
B. IP address + port number
C. Only MA
D. address

Correct Answer:C

Question 113

- (Exam Topic 1)
The ACL on the ARG3 series routers supports two matching sequences, configuration sequence and automatic sorting. ()

A. True
B. False

Correct Answer:A

Question 114

- (Exam Topic 2)
The following statement about static routing is wrong ()

A. Cannot automatically adapt to changes in network topology
B. Manual configuration by network administrator
C. Low system performance requirements
D. Routers need to exchange routing information

Correct Answer:D

Question 115

- (Exam Topic 1)
In the network shown in the figure below, switch A and router A are connected by two links, and the two links are aggregated in manual load sharing mode. The aggregated port number is 1, and the aggregated link performs data forwarding It needs to carry VLAN TAG100, and switch A uses trunk link. Which of the following configurations should be used for switch A? ()
H12-811_V1.0 dumps exhibit

A. interface Eth-Trunk 1 Port link-type trunkPort trunk allow-pass vlan 100#Interface GigabitEthernet0/0/1Eth-trunk 1#Interface GigabitEthernet0/0/2Eth-trunk 1#
B. interface Vlanif 100Ip address10.0.12.1255.255.255.0#
C. interface Eth-Trunk 1Ip address10.0.12.1255.255.255.0#
D. interface Eth-Trunk 1 Mode lacp-staticPort link-type trunkPort trunk allow-pass vlan 100#Interface GigabitEthernet0/0/1Eth-trunk 1#Interface GigabitEthernet0/0/2Eth-trunk 1#

Correct Answer:D