Free HPE0-S59 Exam Dumps

Question 11

Which statement about login redistribution is true?

A. Login redistribution is available only If HPE Primera or HPE Alletra is connected directly to the HPE Synergy frame
B. Login redistribution is a licensed feature and the number of licenses required depends on the number of active ports
C. Login redistribution is supported only on the HPE Synergy Virtual Connect SE 32Gb FC Modules
D. Login redistribution is used for login balancing when they are not distributed evenly over the FC links

Correct Answer:C

Question 12

Which statement about an HPE Oneview support dump is true?

A. Appliance support dump by default contains a logical enclosure support dump
B. Support dump is a binary file that can be opened only in a dedicated application
C. Support dump can be created if HPE Virtual Connect modules are installed in the frame
D. Preview support dump is available only when creating an appliance support dump

Correct Answer:B

Question 13

After deploying HPE Superdome Flex 280 you need to check Core Analysis Engine (CAE) Log.
Click the appropriate section in the HPE Superdome Flex 280 management interface that will allow you to complete this task.
HPE0-S59 dumps exhibit
Solution:

Does this meet the goal?

A. Yes
B. No

Correct Answer:A

Question 14

Your customer plans to deploy VMware ESXi 7 0 U2 and they are looking for a hardware platform mat wilt allow them to use up to 24 TB of physical memory.
Which HPE compute system meets this customer's requirements?

A. HPE ProLiant DL380 Gen 10 Plus
B. HPE Synergy 480 Gen10 Plus
C. HPE ProLiant DL560 Gen10
D. HPE Superdome Flex 280

Correct Answer:A

Question 15

Your customer plans to use HPE Primera to boot HPE Synergy compute nodes. They currently have two HPE Virtual Connect SE 100Gb F32 Module for Synergy modules installed in the frame. The customer wants to use FC as a storage access protocol
What must be done to complete this task?

A. Enable FC primary and secondary boot on the modules through the HPE OneView interface
B. FC connectivity on the modules should be enabled through the service console by disabling FCoE.
C. Add FC upgrade licenses in HPE OneView that will enable FC connectivity for the modules
D. Enter both modules into a maintenance mode, then enable FC connectivity through CLI

Correct Answer:B