Free N10-007 Exam Dumps

Question 56

- (Exam Topic 1)
An administrator is moving to a new office. There will be several network runs through the ceiling area of the office. Which of the following is the BEST to utilize in these areas?

A. Single-mode fiber-optic cabling
B. Cat 5e-rated cabling
C. Cat 6-rated cabling
D. Plenum-rated cabling

Correct Answer:D

Question 57

- (Exam Topic 2)
Which of the following ports are MOST commonly used to interactively configure a networking device? (Select TWO).

A. 21
B. 22
C. 23
D. 53
E. 67

Correct Answer:BC

Question 58

- (Exam Topic 2)
Which of the following protocols would be used to send email to an email server?

A. NTP
B. FTP
C. SNMP
D. SMTP

Correct Answer:D

Question 59

- (Exam Topic 1)
A contractor is setting up and configuring conference rooms for a convention. The contractor sets up each room in the conference center to allow wired Internet access going to individual tables. The contractor measured the distance between the hotel’s patch panel to the jack, and the distance is within Cat 5e specifications. The contractor is concerned that the room will be out of specification if cables are run in each room from the wall jacks. Which of the following actions should the contractor take to ensure the cable runs meet specifications and the network functions properly?

A. Place a switch at the hotel’s patch panel for connecting each room’s cables
B. Place a switch on each table to ensure strong connectivity
C. Place repeaters between the patch panel and the rooms
D. place a switch at the wall jack and run the cables in the room from there

Correct Answer:A

Question 60

- (Exam Topic 3)
A technician needs to limit the amount of broadcast traffic on a network and allow different segments to communicate with each other. Which of the following options would satisfy these requirements?

A. Add a router and enable OSPF.
B. Add a layer 3 switch and create a VLAN.
C. Add a bridge between two switches.
D. Add a firewall and implement proper ACL.

Correct Answer:B
We can limit the amount of broadcast traffic on a switched network by dividing the computers into logical network segments called VLANs.
A virtual local area network (VLAN) is a logical group of computers that appear to be on the same LAN even if they are on separate IP subnets. These logical subnets are configured in the network switches. Each VLAN is a broadcast domain meaning that only computers within the same VLAN will receive broadcast traffic.
To allow different segments (VLAN) to communicate with each other, a router is required to establish a connection between the systems. We can use a network router to route between the VLANs or we can use a ‘Layer 3’ switch. Unlike layer 2 switches that can only read the contents of the data-link layer protocol header in the packets they process, layer 3 switches can read the (IP) addresses in the network layer protocol header as well.