Free NSE7_SDW-6.4 Exam Dumps

No Installation Required, Instantly Prepare for the NSE7_SDW-6.4 exam and please click the below link to start the NSE7_SDW-6.4 Exam Simulator with a real NSE7_SDW-6.4 practice exam questions.
Use directly our on-line NSE7_SDW-6.4 exam dumps materials and try our Testing Engine to pass the NSE7_SDW-6.4 which is always updated.

Exam Code: NSE7_SDW-6.4
Exam Title: Fortinet NSE 7 - SD-WAN 6.4
Vendor: Fortinet
Exam Questions: 36
Last Updated: November 15th,2024

Question 1

Refer to the exhibit.
NSE7_SDW-6.4 dumps exhibit
Which statement about the command route-tag in the SD-WAN rule is true?

A. It enables the SD-WAN rule to load balance and assign traffic with a route tag
B. It tags each route and references the tag in the routing table.
C. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
D. It ensures route tags match the SD-WAN rule based on the rule order

Correct Answer:D

Question 2

In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

A. Traffic has matched none of the FortiGate policy routes.
B. Matched traffic failed RPF and was caught by the rule.
C. The FIB lookup resolved interface was the SD-WAN interface.
D. An absolute SD-WAN rule was defined and matched traffic.

Correct Answer:AC

Question 3

Refer to the exhibit.
NSE7_SDW-6.4 dumps exhibit
What must you configure to enable ADVPN?

A. On the hub VPN, only the device needs additional phase one sett
B. ADVPN should only be enabled on unmanaged FortiGate devices.
C. Each VPN device has a unique pre-shared key configured separately on phase one
D. The protected subnets should be set to address object to all (0.0 .0. o/o).

Correct Answer:C

Question 4

Which three parameters are available to configure SD-WAN rules? (Choose three.)

A. Application signatures
B. Type of physical link connection
C. URL categories
D. Source and destination IP address
E. Internet service database (ISDB) address object

Correct Answer:BDE

Question 5

What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

A. The FortiGate cloud key has not been added to the FortiGate cloud portal.
B. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager
C. The zero-touch provisioning process has completed internally, behind FortiGate.
D. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
E. A factory reset performed on FortiGate.

Correct Answer:AC