Free NSE7_SDW-7.0 Exam Dumps

No Installation Required, Instantly Prepare for the NSE7_SDW-7.0 exam and please click the below link to start the NSE7_SDW-7.0 Exam Simulator with a real NSE7_SDW-7.0 practice exam questions.
Use directly our on-line NSE7_SDW-7.0 exam dumps materials and try our Testing Engine to pass the NSE7_SDW-7.0 which is always updated.

Exam Code: NSE7_SDW-7.0
Exam Title: Fortinet NSE 7 - SD-WAN 7.0
Vendor: Fortinet
Exam Questions: 35
Last Updated: November 15th,2024

Question 1

Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )

A. A peer ID is included in the first packet from the initiator, along with suggested security policies.
B. XAuth is enabled as an additional level of authentication, which requires a username and password.
C. A total of six packets are exchanged between an initiator and a responder instead of three packets.
D. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.

Correct Answer:BC

Question 2

Refer to the exhibit.
NSE7_SDW-7.0 dumps exhibit
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
B. FortiGate has terminated the session after a change on policy ID 1.
C. Changes have been made on firewall policy ID 1 on FortiGate.
D. Firewall policy ID 1 has source NAT disabled.

Correct Answer:C

Question 3

Refer to the exhibits.
Exhibit A
NSE7_SDW-7.0 dumps exhibit
Exhibit B -

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.
If port2 is detected dead by FortiGate, what is the expected behavior?

A. Port2 becomes alive after three successful probes are detected.
B. FortiGate removes all static routes for port2.
C. The administrator manually restores the static routes for port2, if port2 becomes alive.
D. Host 8.8.8.8 is reachable through port1 and port2.

Correct Answer:B
This is due to Update static route is enable which removes the static route entry referencing the interface if the interface is dead

Question 4

Refer to the exhibit.
NSE7_SDW-7.0 dumps exhibit
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

A. Set priority 10.
B. Set cost 15.
C. Set load-balance-mode source-ip-ip-based.
D. Set source 100.64.1.1.

Correct Answer:AB

Question 5

Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

A. The sdwan_service_id flag in the session information is 0.
B. All SD-WAN rules have the default setting enabled.
C. Traffic does not match any of the entries in the policy route table.
D. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.

Correct Answer:AC